DDM4 300 S | 10.3"

Daniel Defense DDM4 300 S Black

The Daniel Defense DDM4 300S AR-15 rifle was designed for those seeking a high-performance short-barreled rifle chambered for the versatile .300 Blackout cartridge. The 300S is built around a 10.3-inch barrel and uses standard 5.56 bolts and magazines to deliver .30-caliber rounds with higher muzzle energy than comparable 5.56-mm platforms. With a wide selection of factory ammunition for all types of home defense, target shooting, hunting, suppressed operations, and tactical applications, the 300S is capable of delivering exceptional performance in a compact, easy-to-handle package. The ambidextrous GRIP-N-RIP charging handle is suitable for both left- and right-handed shooters. This rifle also comes equipped with the ergonomic Daniel Defense stock and pistol grip.

MATERIALS & CONSTRUCTION

LOWER RECEIVER: Mil-Spec with an extended, flared magazine well and a QD swivel mounting point on the rear receiver. CNC-machined from 7075-T6 aluminum, Type III hard-anodized

UPPER RECEIVER: Mil-Spec with indexing marks and M4 feed ramps. CNC-machined from 7075-T6 aluminum, Type III hard-anodized

BARREL: Chrome-molybdenum-vanadium steel, cold-forged, 1:8 twist, 10.3" S2W profile, chrome-plated, heavy phosphate-coated, and HP/MPI-tested

GAS SYSTEM: Pinned low-profile gas block, CNC-milled from 4140 hardened steel with Mil-Spec heavy phosphate coating, pistol-length, direct impingement

MUZZLE: Daniel Defense flash suppressor, 17-4 PH stainless steel, salt bath nitride-coated

BOLT CARRIER GROUP: M16 profile, Mil-Spec MP tested, chrome-plated, properly stacked gas key

BUFFER: H-buffer

SIGHTS: Sold separately

HANDGUARD: Daniel Defense DDM4 Rail 9.0, CNC-machined from 6061-T6 aluminum, Type III hard-anodized

CHARGE HANDLE: GRIP-N-RIP charge handle, body CNC-machined from 7075-T6 aluminum, grips and locking mechanism CNC-machined from 6061-T6 aluminum, high-performance stainless steel roll pins, Type III hard-anodized

RECEIVER EXTENSION: Six-position Mil-Spec 7075-T6 aluminum

STOCK: Daniel Defense buttstock, glass-filled polymer with soft-touch coating

PISTOL GRIP: Daniel Defense pistol grip, glass-filled polymer with soft-touch coating

GRIP: Daniel Defense vertical grip, glass-filled polymer with soft-touch coating

RAIL PANEL: Daniel Defense Santoprene rail panels, heat-resistant up to 300° Fahrenheit

Made in the USA!

https://www.youtube.com/watch?v=WnHQkGlOKp8&t=1s

A firearm acquisition permit is required to purchase this weapon.

Please send us the following two documents immediately after or before making your online purchase:
1. All three copies of the approved firearm acquisition permit (WES), in original form and signed.
2. A copy of an official form of identification (ID card or passport)

Or bring the above documents with you when you pick up the firearm at our store.

Please send the documents to info@thoron.ch or to the following address:

Thoron AG
Bahnhofstrasse 25a
6422 Steinen