DDM4 V1 | 16"

Daniel Defense DDM4 V1 - 5.56mm NATO | Black

The DDM4 V1 features a cold-hammered 16-inch M4-profile barrel, a carbine gas system, and a forged front sight base from Daniel Defense. The 12-inch Picatinny quad rail allows the shooter to mount a flashlight or sight in front of the front sight—for optimal ergonomics and an unobstructed field of view. Quick-detach (QD) mounting points are integrated on both sides of the rail at the front and rear to allow for a sling to be attached on either side. The new ambidextrous GRIP-N-RIP charging handle is suitable for both right- and left-handed shooters. The rifle also comes with the ergonomic Daniel Defense buttstock and pistol grip.

MATERIALS & CONSTRUCTION

· LOWER: Mil-Spec with extended magazine well and rear QD attachment point. CNC-machined from 7075-T6 aluminum, Type III hard-anodized

· UPPER: Mil-Spec with markings and M4 feed ramps. CNC-machined from 7075-T6 aluminum, Type III hard-anodized

· BARREL: Chromium-molybdenum-vanadium steel, cold-hammered, 1:7 twist, 16" M4 profile, hard chrome-plated, MP-tested, Mil-Spec phosphate coating, HP/MPI-tested

· GAS SYSTEM: Daniel Defense forged front sight mount, carbine length, direct gas system

· MUZZLE DEVICE: Daniel Defense flash suppressor made of 17-4 PH stainless steel, treated with a nitrite salt bath

· BOLT CARRIER GROUP: M16 profile, Mil-Spec MP-tested, hard chrome-plated, correctly riveted gas key

· BUFFER: H-buffer

· SIGHTS: Daniel Defense A1.5 fixed rear sight (CNC-milled from 6061-T6 aluminum, Type III hard-anodized); Daniel Defense forged front sight carrier

· HANDGUARD: Daniel Defense DDM4 Rail 12.0 FSP, CNC-machined from 6061-T6 aluminum, Type III hard-anodized

· CHARGING HANDLE: GRIP-N-RIP, body CNC-machined from 7075-T6 aluminum, grips & latch made of 6061-T6 aluminum, stainless steel pins, Type III hard-anodized

· STOCK TUBE: 6-position Mil-Spec made of 7075-T6 aluminum

· STOCK: Daniel Defense stock, polymer with a soft-touch finish

· PISTOL GRIP: Daniel Defense pistol grip, polymer with a soft-touch finish

· VERTICAL GRIP: Daniel Defense vertical grip, polymer with a soft-touch finish

· RAIL PANELS: Daniel Defense rail panels made of Santoprene, heat-resistant up to 150 °C

A cantonal exemption permit (ABG) is required to purchase this firearm.

Please send us the following documents immediately before or after your online purchase:
1. All three copies of the approved cantonal exemption permit (ABG), in original and signed.
2. A copy of a valid government-issued ID (identity card or passport)

Or bring the above documents with you when you pick up the firearm at our store.

Please send the documents to the following address:

Thoron AG
Bahnhofstrasse 25a
6422 Steinen