Benelli M4 Side Saddles

GG&G has incorporated a unique design into the Benelli M4 Side Saddle (six-round version). The configuration allows for quick access to ammunition at an angle that is optimally suited to the hand’s position. The design of the Benelli M4 Side Saddle facilitates both loading the magazine tube and loading the chamber.

IMPORTANT NOTE:

This product is not compatible with the Benelli M4 equipped with the factory-installed collapsible stock!

Additional Note:

While other side-saddle manufacturers use a hollow rubber tube as a cartridge holder with side walls that easily deform due to heat and the constant pressure of the shotgun shell—causing the cartridge to sit loosely in the holder—GG&G relies on a solid rubber cartridge holder with a specified Shore hardness.

This solid rubber construction retains its shape and ensures a permanently secure fit that you can rely on for years to come.

Benelli M4 Side Saddle – Technical Specifications:

- No modifications to the Benelli M4 are required for installation

- All GG&G Benelli M4 Side Saddle models are securely mounted to the receiver at two points using the included mounting hardware

- Installation is performed through the trigger assembly pin hole and via a GG&G-supplied receiver end plate, which serves as the rear mounting point

- The receiver end plate is simply mounted between the rear of the receiver and the stock

- A non-marking backplate protects the receiver’s surface from damage

- The Six-Shot Side Saddle holds 12/70 ammunition at a unique 15-degree angle to allow for quick loading of the magazine tube from below or the chamber from above

- The cartridges can be held with the base facing up or down, depending on the shooter’s loading preference

- Rugged, oil-resistant, and replaceable cartridge retention system

- Made from 6061T6 aluminum

- Black MilSpec Type III hard anodized finish

- Ergonomic design with weight-reducing cutouts

- All edges are rounded for safety

- Made in the USA